|
|
|
|
Photo |
Part # |
Description |
Price |
|
|
|||
|
|
4037-30 |
Brake bracket nut, cadmium plated, made in USA (1930 & 1931 - 45" twins) |
$14.00 |
|
|
|||
|
|
4046-14 |
Brake band rivets, set of 9, made in USA. (1914 to 1930). |
$3.50 |
|
|
|||
|
|
4046-14a |
Brake band rivets, set of 11, made in USA. (1931 to 1934). |
$4.25 |
|
|
|||
|
|
4066-29 |
Rear brake rod spring (later 1929-1934 singles & twins) These are zinc plated so they will have to be stripped and parkerized. |
$6.00 |
|
|
|||
|
|
4068-14 |
Shifter rod end, cadmium plated, made in USA (1925 to 1936 twins (except 1936 - 61"), 1928 to 1934 singles) |
$20.00 |
|
|
|||
|
|
4073-29A |
Brake arm clamp bolt, parkerized, made in USA (Later 1929 to 1931 singles & 45" twins, 1932 1934 - 21" singles) Includes 0214 washers and 0117 hex nut. |
$7.00 |
|
|
|||
|
|
4073-32 |
Front brake rod, parkerized, made in USA (1932 to 1934 - 45" twins) Includes (2) #0212 washers and (2) #0290 cotter pins. |
$28.00 |
|
|
|||
|
|
4078-26 |
Footbrake shaft lock washer, parkerized (1929-1934) Impossible to find elsewhere and imperative for an accurate restoration. |
$6.00 |
|
|
|||
|
|
4117-30 |
Front hub stabilizer. Cadmium plated like original. Made in the Netherlands. (1930-1952) |
$25.00 |
|
|
|||
|
|
4122-30 |
Stabilizer collar studs, made in USA (1930 to 1952 - 45" twins, 1930 to 1934 C singles) |
$9.50 |
|
|
|||
|
|
4123-31 |
Brake operating lever, made in USA (1931 to 1936 - 45", 74" & 80", 1937 to 1952 - 45" twins, 1931 to 1934 C singles) Available through Resurrection Cycle Works |
|
|
|
|||
|
|
4124-31A |
Operating stud grease nipple, parkerized, made in USA (1931 to 1936 - 45", 74" & 80", 1937 - 45" twins, 1930 to 1934 C singles) |
$8.00 |
|
|
|||
|
|
4125-28A |
Front brake shoe spring, made in USA (1929 to 1939 - 45" twins, 1928 to 1936 - 74" & 80" twins) |
$7.00 |
|
|
|||
|
|
4133-31 |
Brake shackle fork stud, cadmium plated, made in USA (1931 to 1936 - 45", 74" & 80", 1937 to 1939 - 45" twins, 1931 to 1934 C singles) Includes stud, 0224 flat washer, 0261 lock washer, 0127 hex nut and 0291 cotter pin. Click on small photo to see complete part. |
$24.00 |
|
|
|||
|
|
4140-29 |
Grease nipple extension. Made in the Netherlands. (1929-1952) |
$12.00 |
|
|
|||
|
|
4140-29 kit |
grease nipple extension kit, made in USA. (Later 19298 to 1952 - 45" twins) Includes late style grease nipple, grease nipple extension and grease drain. |
$13.00 |
|
|
|||
|
|
4142-30 |
Front brake cable oiler. (Late 1930-1948) |
$22.00 |
|
|
|||
|
|
BL-29 |
Rear brake linings and rivets, made in USA. (Early 1929 - 45" twins) Linings are 1-1/4" wide by 6-3/4" and 5-5/8" in length and include 9 rivets. Linings require holes to be drilled and countersunk. |
$25.00 |
|
|
|||
|
|
4145-28 |
Front brake inner cable, made in USA (1929-later) |
$8.00 |
|
|
|||
|
|
4160-28 |
Front brake cable clamp, made in USA (1928-1960) |
$11.00 |
|
|
|||
|
|
4162-30 |
Front brake coil clip, parkerized, made in USA. (1930 to 1957) |
$9.00 |
|
|
|||
|
|
4163-30 |
Control coil clamp, parkerized, made in USA (1930 to 1939 - 45" twins, 1930 to 1936 - 74" & 80" twins) |
$30.00 |
|
|
|||
|
|
4165/4166-28 |
Front brake control coil adjusting sleeve and nut, parkerized, made in USA (1928 to 1940) |
$11.00 |
|
|
|||
|
|
4170-28 |
Control wire lower connection for front brake cable, made in USA (1928 to 1940) |
$20.00 |
|
|
|||
|
|
4506-29A |
Switch box fastening bolts and lock washers, made in USA (Later 1929 to 1936) |
$16.00 |
|
|
|||
|
|
4521-26 |
Ignition key, made in USA (1926-1936) |
$8.00 |
|
|
|||
|
|
4544-28A |
Tail lamp connection clamp, parkerized, made in USA. (1928 to 1936 - 45 twins & singles) This clamp attaches to the seat post tube and is used for the tail lamp wire terminal. Back ordered |
$24.00 |
|
|
|||
|
|
4544/4545-28 |
Tail lamp connection clamp and connection bracket, made in USA (1928 to 1936, except 1936 - 61" twins) Includes 4544-28, 4545-28 and all hardware. |
$40.00 |
|
|
|||
|
|
4545-28 |
Tail lamp connection bracket, made in USA (1928 to 1936, except 1936 - 61" twins) |
$20.00 |
|
|
|||
|
|
4567-29 |
Switch lamp bulb, dual-contact (1929 to 1931, 1932 to 1936 - 45" , 74" & 80" twins & C singles) |
$4.00 |
|
|
|||
|
|
4720-15 |
Small rubber tubing used over tail lamp wire at rear fender (1915-1933) 12" piece can be cut to length. |
$2.50 |
|
|
|||
|
|
4726-24 |
Wire clamp, large, made in USA (1924 to 1930 all models, 1931 to 1934 singles) One clamp is used under gas tank. |
$15.00 |
|
|
|||
|
|
4726-31 |
Wire clip (on triple clamp)(2), made in USA. (1931 to 1936 - 45", 74" & 80" twins & C singles) These mount under the dash. |
$9.00 |
|
|
|||
|
|
4727-23 |
Wire clamp, parkerized, made in USA (1926 to 1933 singles & 45" twins) This clamp is used to secure the tail lamp copper tubing to the left upper frame stay. |
$10.00 |
|
|
|||
|
|
4728-25 |
Wire retaining clamp, made in USA (1929 to 1939 twins) Two required, one on front down tube and one on seat post. |
$11.00 |
|
|
|||
|
|
4729-30 |
Timer wire & control coil clip, made in USA (1930 to 1933 twins) |
$30.00 |
|
|
|||
|
|
4730-30 |
Lighting cable clamp, made in USA. (1930 to 1936, except 1936 - 61" twins) |
$12.00 |
|
|
|||
|
|
4735-30 |
Wiring harness for 1930 models including the extra wires for twin headlights, complete with wiring diagram, made in USA |
$120.00 |
|
|
|||
|
|
4735-31 |
Wiring harness for 1931 -1936 models with single headlight, complete with wiring diagram, made in USA |
$110.00 |
|
|
|||
|
|
4735-31 brake |
Wiring harness for 1931 -1936 models with single headlight, complete with wiring diagram, made in USA. Includes wires for rear brake light switch. |
$135.00 |
|
|
|||
|
|
4760-26 |
Horn button, complete, chrome plated with cloth covered wire. (1926 - 1957) |
$28.00 |
|
|
|||
|
|
4760-29 |
Light switch complete, identical to original with cloth covered wires, made in USA (1929 to 1957 all models) |
$38.00 |
|
|
|||
|
|
4787-26 |
Relay mounting screws and lock washers, parkerized, made in the Netherlands (1926 to 1957) |
$6.00 |
|
|
|||
|
|
4927-15 |
Tail lamp bulb, 6 volt, single contact for use without a brake switch. (1915 - 1939) |
$4.00 |
|
We accept PayPal and money orders. |
|
|
Home
-|-
Restoration Guide
-|-
Parts for Sale
Copyright
© 2005 Vintage Motorcycle Works |
